Software Manual

B.70
statport
Remote Copy User’s Guide InForm OS Version 2.3.1
–rw
Display reads and writes separately. If this option is not used, then the total of reads plus
writes is displayed.
–d <secs>
Sets the interval, in seconds, that statistics are sampled using an integer from 1 through
2147483. If no interval is specified, the option defaults to an interval of two seconds.
–iter <number>
Specifies that I/O statistics are displayed a specified number of times as indicated by the
num argument using an integer from 1 through 2147483647.
–idlep
Specifies the percent of idle columns in the output.
–begin
Computes I/O averages from the system start time. If not specified, the average is computed
since the first iteration of the command.
–sortcol <col> [,<dir>][:<col>[,<dir>]...]
Sorts command output based on column number <col>. Columns are numbered from left
to right, beginning with 0. You must specify a column number. In addition, you can specify
the direction of sorting
<dir> as follows:
inc
Sort in increasing order (default).
dec
Sort in decreasing order.
Multiple columns can be specified separated by a colon (
:), and rows that have the same
earlier columns will be sorted by the values in the later columns.
–filt <fspec>
Specifies that statistics that fall below the threshold as specified by the <fspec>
arguments where <fspec> is <type>, <op>, <meas>, <val>, are filtered out and not
displayed. The
type, operation, meas, and value arguments are separated with one
comma.
<type>
The type argument can be specified with one of the following arguments: