Software Manual

3.19

Setting Up Remote Copy

InForm OS Version 2.3.1 Remote Copy User’s Guide

◆ <link_IP_addr> is the link IP address for the target system (for example,172.16.1.12

and 172.16.2.12).

3.5.1.2 Setting Up the Backup Server

The commands used to set up the backup storage server (InServ2) are the same as those used

to set up the primary server (InServ1), except that they create the links in the opposite

direction.

To set up the backup storage server (InServ2)

1 Start Remote Copy as follows:

2 Define a target for InServ2:

◆ <target_name> is the target name (in this example, InServ1)

◆ IP states that this is an IP link.

◆ <n:s:p> specifies the node that contains the IP connections to the target.

NOTE: The command for RCFC target creation is:

#creatercopytarget <target_name> FC <node_WWN> <n:s:p:WWN>

<n:s:p:WWN>

NOTE: You can only configure one link per target definition per node. All

examples in this guide use the first pattern illustrated in Figure 2-9 on page 2.17,

where links are created between the lowest numbered node in each member of

the Remote Copy pair and the highest numbered node in each member of the

Remote Copy pair.

On InServ2:

# startrcopy

On InServ2:

creatercopytarget <target_name> IP <n:s:p>:<link_IP_addr>