Instruction Manual

3PAR InForm Management Console 4.1.0 User’s Guide
320-200231 Rev A 143
Class 2
Indicates whether Fibre Channel service Class 2 is
Disabled, Ack 1 or Ack 0.
VCN
For fabric attached ports, indicates the VLUN change
notification setting. When set to Enabled, notices are
generated and sent to the fabric controller. When set to
Disabled, no notification is sent.
Unique Node
WWN
Indicates whether the node's WWN is Enabled or
Disabled. Not available for systems running InForm OS
2.2.4 or lower.
Interrupt
Coalesce
If Disabled, each I/O generates a separate interrupt to
the HBA port driver rather than generating one interrupt
for multiple I/O completion. Not available for systems
running InForm OS 2.2.4 or lower.
Fibre
Channel
Settings
Topology
Type of connection (Private Loop, Public Loop, or
Point-Point).
Class
Identifies which Fibre Channel classes of service are
enabled (2, 3, or 2/3). 2/3 indicates that both Class 2
and Class 3 are enabled.
Adaptor Type
Model of the Fibre Channel adapter that contains the
port (for example, QLOGIC 2302).
Remote Port
WWN
World Wide Name of the remote port.
Remote Node
WWN
World Wide Name of the remote node.
Mode Change
Indicates whether port mode change from initiator to
target or vice versa is Allowed or Prohibited. This
setting is configured using the InForm CLI command
controlport.
Link State The state of the link.
Note: Persona information is not displayed on systems using InForm OS 2.3.1 or higher.
Persona
(not shown)
Persona Number for the current port persona setting.