Operating System Software Owner manual

NOTE: See also showvv -rcopy in the HP 3PAR Inform OS CLI Reference.
Issuing Remote Copy Commands
• Enter Remote Copy commands using the HP 3PAR Command Line Interface (CLI).
For more information, see the HP 3PAR CLI Reference Guide.
• As long as you are using HP 3PAR Remote Copy Software with the default group policy
enabled (see “Setting Volume Group Policies” (page 89)), these configuration commands
need only be issued on the primary storage system:
creatercopygroup, removercopygroup, admitrcopyvv, dismissrcopyvv,
setrcopygroup pol/period, startrcopygroup, stoprcopygroup
If Remote Copy is configured to mirror commands, these commands are automatically mirrored
to the backup system.
• When you issue commands that are mirrored from one system to the other, there is a five-minute
timeout limit. After five minutes, if the other system does not respond to a command, Remote
Copy displays the following error message:
target system <target_name> could not be contacted
Issuing Remote Copy Commands 223