Operating System Software Owner manual

offline
Holds the specified port offline indefinitely. Issue controlport rst to bring the port back
online.
lip
Specifies that a Loop Initialization Primitive (LIP) command is issued from the port if there is a
private loop topology. If the -c option is specified, then the LIP command is issued through
the specified drive cage. If there is a point-to-point topology, then the link is reset. If there is a
public loop or fabric topology, then a Registered State Change Notification is issued to the
fabric controller.
ct
Sets the connection type. The specified port will be reset. Note that this option is deprecated
and will be removed in a subsequent release.
cl2
Specifies the Fibre Channel Class-2 parameter of the port. The specified port will be reset.
Note that this option is deprecated and will be removed in a subsequent release.
rate
Specifies the data rate of the Fibre Channel port. The specified port will be reset.
vcn
Sets the VLUN Change Notification (VCN) generation support (enable or disable). When VCN
generation support is enabled with a public loop or fabric topology, a Registered State Change
Notification (RSCN) message is issued to the fabric controller whenever a VLUN is created or
removed. In addition, if enabled with a public loop topology, a Loop Initialization (LIP) is issued
from the port whenever a VLUN is created or removed.
persona
Port personas have been removed and this command no longer sets them. As port personas
have been replaced by host personas, this command will print the host persona commands to
use instead. See createhost and sethost for setting host personas and controlport config
for setting port parameters.
nssync
Verifies current port database against the Name Server when a fabric is attached. Entries
present in the database but missing from the Name Server are removed. Using this command
is not required under normal circumstances.
rcip addr
Sets the Remote Copy interface to use the specified IP address and netmask. Refer to
“SPECIFIERS” (page 235) for parameters required to issue this subcommand.
rcip gw
Sets the gateway for one or more Remote Copy interfaces. Only for RCIP ports. Refer to
“SPECIFIERS” (page 235) for parameters required to issue this subcommand.
rcip delete
Deletes the configuration for one or more specified Remote Copy interfaces. Refer to
“SPECIFIERS” (page 235) for parameters required to issue this subcommand.
rcip mtu
Sets the Maximum Transfer Unit (MTU) size for the specified Remote Copy interface(s), overriding
the default of 1500. The largest supported value is 9000 and the smallest is 100. Only for
RCIP ports. Refer to “SPECIFIERS” (page 235) for parameters required to issue this subcommand.
rcip state up|down
Sets the specified Remote Copy interface(s) as either up or down. Only for RCIP ports. Refer
to “SPECIFIERS” (page 235) for parameters required to issue this subcommand.
rcip speed
Sets the specified Remote Copy interface(s) to use the specified speed and duplex, or to auto
negotiate speed and duplex. The default is auto. Only for RCIP ports. Refer to “SPECIFIERS”
(page 235) for parameters required to issue this subcommand.
233