Operating System Software Owner manual

showport
NAME
showport -- The showport command displays information about ports in the system.
SYNTAX
showport [options] [-failed] [-sortcol <col>[,<dir>]]
AUTHORITY
Any role in the system.
OPTIONS
-i
Shows port hardware inventory information.
-c
Displays all devices connected to each loop (by position on the loop). Position 0 is the cage
connected directly to the node on this loop. Position n is the (n + 1) cage on the loop. Thus a
"pos" value of 1 means this cage is the second cage away from the node on the loop.
-par
Displays a parameter listing such as the configured data rate of a port and the maximum data
rate that the card supports. Also shown is the type of attachment (Direct Connect or Fabric
Attached) and whether the unique WWN and VCN capabilities are enabled.
-rc
Displays information that is specific to the Remote Copy ports.
-rcfc
Displays information that is specific to the Remote Copy Fibre Channel (RCFC) ports.
-rcip
Displays information specific to the Ethernet Remote Copy ports.
-iscsi
Displays information about iSCSI ports.
-iscsiname
Displays iSCSI names associated with iSCSI ports.
-sfp
Displays information about the SFPs attached to ports.
-ddm
Displays information about the SFPs DDM. This option must be used with the -sfp option.
-d
Displays detailed information about the SFPs attached to ports. This option is used with the
-sfp option.
-failed
Shows only failed ports.
-state
Displays the detailed state information.
-s
Displays the detailed state information.
262 The Remote Copy Commands