Operating System Software Owner manual
The columns in the previous example are identified as follows:
• N:S:P. The physical position of the port, in the syntax node:slot:port.
• State. State of the port.
ready. The port is online and ready for use.◦
◦ loss_sync. The port is not physically connected to anything.
◦ config_wait. Firmware has yet to be initialized.
◦ login_wait. Fibre Channel adapter is attempting port and process logins with all loop
ports.
◦ error. Fibre Channel adapter has experienced an unrecoverable error.
◦ non_participate. Port is logically isolated from the Fibre Channel loop.
◦ offline. The port is offline.
• HwAddr. A unique identifier of the port hardware used for Remote Copy connection. For an
RCIP port, it is the MAC address of the port.
• IPAddr. The IP address of the Remote Copy interface.
• Netmask. Netmask for the Ethernet port.
• Gateway. Gateway address for the Remote Copy interface.
• MTU. Maximum Transfer Unit (MTU) size for the specified Remote Copy interface (default is
1500). The largest supported value is 9000 and the smallest is 100.
• Rate. Data transfer rate for the Remote Copy interface.
• Duplex. Values can be either Full or Half.
• AutoNeg. Autonegotiate.
NOTES
For full showport command information and additional usage examples, refer to the HP 3PAR
Inform OS CLI Reference.
264 The Remote Copy Commands