Operating System Software Owner manual
The following example displays status and information about the end-to-end transport for RCIP
ports:
# showrctransport -rcip
N:S:P State HwAddr IPAddress PeerIPAddress Netmask Gateway MTU Rate Duplex
0:1:1 new 000423C21B72 192.168.25.226 - 255.255.255.0 - 1500 1Gbps Full
0:1:1 new 000423C21B73 192.168.25.226 - 255.255.255.0 - 1500 n/a Half
1:2:1 new 000423ADE95E 192.168.25.227 - 255.255.255.0 - 1500 1Gbps Full
1:2:1 new 000423ADE95F 192.168.25.227 - 255.255.255.0 - 1500 n/a Half
The columns in the previous example are identified as follows:
• N:S:P. The physical position of the port, in the syntax node:slot:port.
• State. Remote copy end-to-end transport state. Can include one of the following results:
• new. Configuration is not completed on this port.
• incomplete. Configuration is not yet completed on the peer port.
• ready. Configuration is completed on this port and the peer port; transport is ready for use.
• missing. A configured transport was disconnected.
• HwAddr. Hardware address of the Ethernet port indicated in the N:S:P column.
• IPAddress. IP address of the Ethernet port indicated in the N:S:P column.
• PeerIPAddress. IP address of the peer Ethernet port to which the port indicated in the
N:S:P column is connected.
• Netmask. Netmask for the IP address.
• Gateway. Address of the gateway.
• MTU. Maximum Transfer Unit (MTU) size for the specified Remote Copy interface (default is
1500). The largest supported value is 9000 and the smallest is 100.
• Rate. Actual bit rate of the port indicated in the N:S:P column.
• Duplex. Values can be either Full or Half.
The following example displays status and information about the end-to-end transport for RCFC
ports:
# showrctransport -rcfc
N:S:P Remote_Node_WWN Remote_Port_WWN State
5:3:2 2FF70002AC000029 21110002AC000029 ready
4:1:1 2FF70002AC000029 20020002AC000029 ready
The columns in the previous example are identified as follows:
• N:S:P. The physical position of the port, in the format node:slot:port.
• Remote_Node_WWN. World Wide name of the node to which the port indicated in the N:S:P
column connects.
• Remote_Port_WWN. World Wide name of the target port to which the port indicated in the
N:S:P column connects.
• State. Indicates whether the end-to-end transport is ready to be used for Remote Copy. Can
be one of the following:
◦ new. The target port is newly discovered and has not yet been used for Remote Copy.
◦ incomplete. Port indicated in the N:S:P column is activated and ready, but the target
port is not yet enabled.
◦ ready. Remote copy link is activated and ready for use.
◦ missing. Ready link was disconnected.
270 The Remote Copy Commands