Operating System Software User Manual

a. Issue the showrcopy command on the failover system (System2).
b. Verify the following:
• The Status of the target (recovered) system is ready
• The Status of all sending links is Up
• The SyncStatus of all volumes in the Primary-Rev volume groups is Syncing
The following example shows the showrcopy command output for System2:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
System1 2 IP ready mirror_config
Link Information
Target Node Address Status Options
System1 0 10.100.33.96 Up
System1 1 10.101.33.96 Up
receive 0 10.100.33.96 Up
receive 1 10.101.33.96 Up
Group Information
Name Target Status Role Mode Options
sync_group_1.r96 System1 Started Primary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 375 localvv.0 413 Syncing (20%) Thu Dec 14 17:58:25 PST 2006
remotevv.1 376 localvv.1 414 Syncing (25%) Thu Dec 14 17:58:25 PST 2006
Name Target Status Role Mode Options
sync_group_2 System1 Stopped Primary Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.0 385 remotevv.0 423 Stopped Thu Dec 14 17:51:48 PST 2006
localvv.1 386 remotevv.1 424 Stopped Thu Dec 14 17:51:44 PST 2006
c. Issue the showrcopy command on the recovered system (System1).
d. Verify the following:
• The Status of the target system is ready
• The Status of all sending links is Up
• The Role of the synchronizing volume groups is Secondary-Rev
• the SyncStatus of all volumes in the Secondary-Rev volume groups is Syncing
The following example shows the showrcopy command output for System1:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
System2 9 IP ready mirror_config
Recovering from Disaster for 1-to-1 Configurations 177