Operating System Software User Manual

CommandDescription
srstatrcvvView historical performance data reports for remote-copy
volumes
startrcopyEnable remote copy on a storage system
startrcopygroupEnable remote copy for a remote-copy volume group
statportView I/O statistics for remote-copy ports
statrcopyView statistics for remote-copy volume groups
statrcvvView statistics for remote-copy volumes
stoprcopyStop remote-copy functionality for all started remote-copy
volume groups
stoprcopygroupStop remote-copy functionality for a specific remote-copy
volume group
syncrcopySynchronize remote-copy volume groups
NOTE: See also showvv -rcopy, showwvv —rcopygroup, and createsv -rcopy in the
HP 3PAR Command Line Interface Reference.
To access this document, go to the HP 3PAR StoreServ Storage site and click the Support link for
your product:
www.hp.com/go/3par
Issuing Remote-Copy Commands
Enter remote-copy commands using the HP 3PAR Command Line Interface (CLI).
For more information, see the HP 3PAR CLI Reference Guide.
To access this document, go to the HP 3PAR StoreServ Storage site and click the Support link for
your product:
www.hp.com/go/3par
If you are using HP 3PAR Remote Copy Software with the default group policy enabled (see “Setting
Volume Group Policies” (page 118)), the following configuration commands need only be issued
on the primary storage system. If remote copy is configured to mirror commands, these commands
are automatically mirrored to the backup system:
• creatercopygroup
• removercopygroup
• admitrcopyvv
• dismissrcopyvv
• setrcopygroup pol/period
• startrcopygroup
• stoprcopygroup
When you issue commands that are mirrored from one system to the other, there is a five-minute
timeout limit. After five minutes, if the other system does not respond to a command, HP 3PAR
Remote Copy displays the following error message:
target system <target_name> could not be contacted
262 Using Remote Copy Commands