Operating System Software User Manual

2. Define a target (for example, the primary system SystemA) on the backup system. On the
backup system (SystemB), issue the following command:
For RCFC:
# creatercopytarget <target_name> FC <node_WWN> <N:S:P>:<WWN> <N:S:P>:<WWN>
where:
<target_name>—Name of the remote-copy target system (SystemA).
FC—Specifies a FC link.
<node_WWN>—WWN of the target node (node 2FF70002AC000060 on SystemA).
<N:S:P>:<WWN>—FC adapter port on the backup system (SystemB), expressed as
node:slot:port, and the WWN of the peer port on the target system (SystemA)
(0:1:1:20110002AC000060 and 1:3:2:21320002AC000060).
For RCIP:
# creatercopytarget <target_name> IP <N:S:P>:<IP_addr> <N:S:P>:<IP_addr>
where:
<target_name>—Name of the remote-copy target system (SystemA).
IP—Specifies an IP link.
<N:S:P>:<IP_addr>—Node on the backup system (SystemB) that contains the IP
connections to the target system, expressed as node:slot:port, and the IP address for
the target system (SystemA) (2:4:1:10.100.33.96 and 3:4:1:10.101.33.96).
3. Define a second target system (for example, the asynchronous periodic backup system SystemC)
for the backup system. On the backup system (SystemB), issue the following command:
For RCFC
# creatercopytarget <target_name> FC <node_WWN> <N:S:P>:<WWN> <N:S:P>:<WWN>
where:
<target_name>—Name of the remote-copy target system (SystemC)
FC—Specifies an FC link
<node_WWN>—WWN of the target node (SystemC)
<N:S:P>:<WWN>—FC adapter port on the backup system (SystemB), expressed as
node:slot:port, and the WWN of the peer port of the target system (SystemC)
For RCIP
# creatercopytarget <target_name> IP <N:S:P>:<IP_addr> <N:S:P>:<IP_addr>
60 Setting Up SLD Remote Copy