Operating System Software User Manual

3 Setting Up the Storage System
The Storage System Setup wizard verifies your HP 3PAR storage system configuration, initializes
the storage system, and runs initialization tests on the storage system.
To set up and configure the storage system:
1. Verify that the Service Processor is on the same subnet of the network as the HP 3PAR StoreServ
7000 Storage system you are setting up.
2. Click the Setup Storage System link in SmartStart wizard step 3, Setup Storage System.
3. The Setup Storage System dialog window displays. Enter the permanent Service Processor IP
address. For more information about Service Processor IP addresses, see the HP 3PAR StoreServ
7000 Storage Installation Guide.
4. Enter the user name setupusr.
5. Enter the password for setupusr that you created in the Service Processor Setup wizard.
Troubleshooting Access
If you cannot access the Storage System Setup wizard, collect the relevant log files and contact
HP support. For more information, see “Troubleshooting System Setup” (page 19).
Locating the Serial Number
The serial number on your HP 3PAR StoreServ Storage system is the seven-digit number located
on the back of the storage system next to the power switch for the node enclosure power cooling
module (PCM1). It begins with “16” (for example, 1612345).
16 Setting Up the Storage System