User's Manual

4.16
Setting Up SSH Connections for Recovery Manager
Recovery Manager for Oracle User’s Guide
where:
◆ <user_name> is the CLI user created in 4.3.7 Setting Up Connections from the Backup
Host to the NetBackup Master Server on page 4.13.
◆ <ss_name> is the system name of the InServ Storage Server attached to the backup
host.
4.3.11 Setting Connections from the Primary Host to the InServ Storage
Server
Skip this step if the primary host has the same SSH key pair as the SSH key pair of the backup
host (see 4.3.4 Generating an SSH Key Pair for the Primary Host on page 4.11). 3PAR Recovery
Manager uses the same CLI user to access the InServ Storage Server from either the backup
host or primary host.
If you created a different CLI user for the primary host, perform the following to set up an SSH
connection from the primary host to the InServ Storage Server.
1 Log in to the primary host as root user.
2 Make sure the SSH key pair exists as follows:
3 Create a CLI user to be used by Recovery Manager to access the InServ Storage Server from
the primary host. Skip this step if you wish to use an existing user (different from the user
created for the backup host).
<backup_host># ssh <username>@<ss_name>
The authenticity of host '<ss_name>' can't be established.
DSS key fingerprint is xx:xx:xx:xx:xx:xx:xx:xx:xx:xx:xx:xx:x:xx:xx.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '<InServ_name>' (DSS) to the list of
known hosts.
<primary_host> # ls ~/.ssh
id_rsa id_rsa.pub authorized_keys known_hosts
<primary_host># ssh <adm_user>@<ss_name>
<adm_user>'s password: <adm_password>
cli% createuser -c <password> <username> all edit