Command Reference Guide

1
You need access to all domains in order to run this command.
Network Interface Configuration
For Details SeeAuthorityDescriptionCommand
“setnet” (page 302)Super, Service
1
Any role granted the
net_set right.
Sets the administration
network interface
configuration.
setnet
“setntp” (page 308)Super, Service
1
Any role granted the
ntp_set right.
Sets the NTP server to which
the HP 3PAR Storage System
synchronizes.
setntp
“shownet” (page 407)Any role in the system.Displays the network
configuration and status.
shownet
1
You need access to all domains in order to run this command.
Port Information
For Details SeeAuthorityDescriptionCommand
“checkport” (page 65)Super, Service
1
Performs a loopback test on
Fibre Channel ports.
checkport
Any role granted the
port_check right.
“controlport” (page 87)Super, Service
1
Controls Fibre Channel or
Remote Copy ports.
controlport
Any role granted the
port_control right.
port_control
“controliscsiport” (page 81)Super, Edit
1
Used to set up the
parameters and
controliscsiport
Any role granted the
port_control right.
characteristics of an iSCSI
port.
“showiscsisession”
(page 392)
Any role in the system.Shows the iSCSI active
sessions per port.
showiscsisession
“showport” (page 440)Any role in the system.Displays system port
information.
showport
“showportarp” (page 449)Any role in the system.Shows the ARP table for
iSCSI ports in the system.
showportarp
“showportdev” (page 450)Any role in the system.Displays detailed
information about devices
on a Fibre Channel port.
showportdev
“showportisns” (page 453)Any role in the system.Show iSNS host information
for iSCSI ports in the system.
showportisns
“showportlesb” (page 454)Any role in the system.Displays Link Error Status
Block information about
showportlesb
devices on a Fibre Channel
port.
“showtarget” (page 488)Any role in the system.Displays unrecognized
targets.
showtarget
“statfcoe ” (page 596)Any role in the system.Shows Fibre Channel over
Ethernet information.
statfcoe
24 Commands Quick Reference