Command Reference Guide
setnode
DESCRIPTION
The setnode command sets the properties of the node components such as the serial number of
the power supply.
AUTHORITY
• Super, Service
• Any role granted the node_set right.
NOTE: You need access to all domains in order to run this command.
SYNTAX
setnode ps <PS_ID> [options] <node_ID>
SUBCOMMAND
ps
Sets the power supply properties.
OPTIONS
-s <serial_number>
Specifies the serial number up to eight characters in length.
SPECIFIERS
<PS_ID>
Specifies the power supply ID.
<node_ID>
Specifies the node ID.
RESTRICTIONS
• Access to all domains is required to run this command.
• At least one option must be specified.
EXAMPLES
The following example displays the node power supply:
cli% shownode -ps
Node PS -Serial- -PSState-- FanState ACState DCState -BatState- ChrgLvl(%)
0 0 -- NotPresent -- -- -- NotPresent 0
0 1 FFFFFFFF OK OK OK OK OK 0
1 0 FFFFFFFF OK OK OK OK OK 0
1 1 -- NotPresent -- -- -- NotPresent 0
cli%
cli% setnode ps 1 -s 12345678 0
cli% shownode -ps
Node PS -Serial- -PSState-- FanState ACState DCState -BatState- ChrgLvl(%)
0 0 -- NotPresent -- -- -- NotPresent 0
0 1 12345678 OK OK OK OK OK 0
1 0 FFFFFFFF OK OK OK OK OK 0
1 1 -- NotPresent -- -- -- NotPresent 0
306 Set Commands