Command Reference Guide

The following example displays more detailed (–d option) information about the same system:
cli% showsys -d
------------General-------------
System Name : S424
System Model : InServ E200
Serial Number : 1100424
System ID : 424
Number of Nodes : 2
Master Node : 0
Nodes Online : 0,1
Nodes in Cluster : 0,1
-----System Capacity (MB)-----
Total Capacity : 6277120
Allocated Capacity : 687872
Free Capacity : 5589248
Failed Capacity : 0
---------System Fan---------
Primary Node ID : 0
Secondary Node ID : 1
State : OK
LED : Green
Speed : Normal
Primary Node ID : 1
Secondary Node ID : 0
State : OK
LED : Green
Speed : Normal
--------System Descriptors--------
Location :
Owner :
Contact :
Comment :
The following example shows system parameters (–param option) for a HP 3PAR storage system:
cli% showsys -param
System parameters from configured settings
---Parameter---- ---Value----
RawSpaceAlertFC : 0
RawSpaceAlertNL : 0
RemoteSyslog : 1
RemoteSyslogHost : 192.168.6.15
SparingAlgorithm : Minimal
CopySpaceReclaim : 0
EventLogSize : 3M
VVRetentionTimeMax : 336 Hours
NOTES
• See “setsys” (page 333) for information on setting the threshold parameters indicated by the
Value column in the output for showsys –param.
• In the output for showsys –param, (from configured settings) indicates that the
system parameters displayed have been successfully read from the Persistent Repository (PR).
If the PR is not available (most likely because of problems with the admin volume), the output
reads (from default settings) and the values displayed would indicate the system
484 Show Commands