Operating System Software Instruction Manual

At this point, if you reassign a system to one that runs a non-supported HP 3PAR OS, the
Additional Targets for Multimode is cleared and disabled, and the additional target pair is
removed.
6. Click Next.
Links
1. A graphical representation of each system's Remote Copy ports appears under Create Links
Between Systems. Click and drag from a port on one system to a port on the other system.
Repeat for a second port.
2. For IP links, in the IP Settings groups for each system/port, all fields are automatically populated
based on the link relationship you established under Create Links Between Systems.
a. (Optional) Enter the gateway address for each system/port.
b. (Optional) Click Apply to test the link configuration, or Ping to test the communication
between the links.
3. For Fibre Channel links, in the Settings groups for each system/port:
a. Connection Type - Select Point for point-to-point mode or Loop for arbitrated loop mode.
b. Configured Rate - Select Auto (default), 1 Gbps, 2 Gbps, or 4 Gbps.
c. Click Apply to test the link configuration, or Ping to test the communication between the
links.
4. Click Next.
NOTE: If Fibre Channel ports are not displayed, the ports might not be zoned correctly, or might
not be physically connected. Refer to “Configuring an RCFC Port” (page 29) for more information.
Groups
1. In the Source group:
a. System - Select the system on which the Remote Copy group will be located.
b. (Optional) Domain - Select the domain in which the Remote Copy group will be located.
c. Group - Enter a name for the Remote Copy group.
d. (Optional) Start group after completion - Select if you want the Remote Copy group to
start mirroring after it is created.
e. (Optional) Do not perform initial sync - Select if you do not want the created Remote Copy
group to be synchronized with its backup group. Before selecting this option verify both
sides are synchronized or it might lead to data inconsistency. (This option is available if
Show tape backup options in Remote Copy wizards was selected in the Preferences.)
2. In the Backup group:
a. Name - The system NOT selected as the source system, automatically appears.
b. Mode - Select Periodic or Synchronous.
c. Sync Period - (Available for Periodic mode only.) If you selected Periodic, select this
checkbox and select second(s), minute(s), hour(s), or day(s) and enter a numeric value
for when you want the source and backup groups to synchronize their data.
d. (Optional) Auto Recover - Select if you want the group to be restarted automatically after
Remote Copy links come back up should the links go down. (Displayed only if Show
advanced options is selected.)
e. (Optional) Over Period Alert - Select if you want an alert to be generated if the
synchronization of a periodic group takes longer than its set synchronization period. This
option is not available for groups in synchronous mode. (Displayed only if Show advanced
options is selected.)
3. Click Add.
4. (Optional) Repeat steps 1 through 3 to create additional Remote Copy groups.
208 Configuring and Managing Remote Copy