Operating System Software Instruction Manual

e. (Optional) Over Period Alert - Select if you want an alert to be generated if the
synchronization of a periodic group takes longer than its set synchronization period. This
option is not available for groups in synchronous mode. (Displayed only if Show advanced
options is selected.)
3. Click Add.
4. (Optional) Repeat steps 1 through 3 to create additional Remote Copy groups.
NOTE: When creating additional groups, if you select a server other than the server selected
during the first instance of group creation, you create a bidirectional Remote Copy relationship
where each storage server is both the primary and backup servers to the other.
5. Click Next.
Virtual Volumes
1. Select a Remote Copy group from the Group list.
2. Under the Source Volume on list, select a virtual volume.
3. Under the Backup Volume on list:
a. Select either Existing or New.
b. If you selected Existing, select a backup virtual volume.
c. If you selected New:
i. Name - Enter a name for the backup virtual volume.
ii. CPG under User CPG - Select a CPG from which the volume's user space is allocated.
iii. CPG under Copy CPG - Select a CPG from which the volume's copy space is allocated.
iv. (Optional) In the Allocation Warning and Allocation Limit text boxes under User CPG
and Copy CPG, enter the appropriate information. You must select the Enabled
checkbox if you want you use these options.
NOTE: When selecting volumes, you can filter the lists to include by clicking the down
arrow and selecting Virtual Volumes, Provisioning, and Virtual Size. To clear the filter, click
Clear.
NOTE: If an RW snapshot is added to the group all RW of the same volume family is
removed. The base parent is also removed.
4. Click Add.
5. (Optional) Repeat steps 1 through 4 to add additional virtual volumes to your Remote Copy
group(s).
6. Click Next to go to the Summary page, or click Finish to complete the wizard.
Summary
Review your settings, then click Finish to complete the wizard.
Editing Remote Copy Targets
To edit a Remote Copy target:
1. Navigate to the Remote Copy Targets screen.
2. Right-click the Remote Copy target you want to edit, then select Edit Target.
The Edit Remote Copy Target dialog box appears.
3. Click Advanced.
4. Enter a value in the Bandwidth field.
5. Enter a value in the Latency field.
6. Click OK.
224 Configuring and Managing Remote Copy