Operating System Software Instruction Manual

After zoning is complete, click OK, and click Verify Configuration when you return to the Set Up
Connections screen.
NOTE: If NPIV peer ports were created, the NPIV port WWNs associated with each peer port
must be included in the same zone as the peer port WWN.
If the configuration is successful, click OK in the Verify Configuration dialog.
If the configuration was not successful, a message similar to the following displays:
Copying Storage Settings and Configurations
To use the Copy Storage Settings and Configurations wizard, the following conditions are required:
• Super user role
• At least one storage system to copy
• Any valid Peer Motion configuration that has source and destination systems
This wizard allows you to copy the following storage settings and configurations from the source
system to the destination system:
• Domain sets
• Domains
• Host sets
• Hosts
• Users
• LDAP configuration
• NTP configuration
• Syslog parameters
• SNMP configuration
When there is no domain license on the destination system and the source system has domains,
a warning message displays, indicating that host sets, hosts, and users will be copied to the <none>
domain, and domain sets and domains will not be displayed.
NOTE:
• Copying the NTP configuration is supported only when you are configuring HP 3PAR Storage
Systems.
• Syslog parameters are copied from the source system to the destination system, but the HP
3PAR Management Console has no syslog parameters management functionality.
• The SNMP configuration is copied from the source system to the destination system, but the
HP 3PAR Management Console has no SNMP management functionality. Additionally, the
user settings are not copied.
254 Using Peer Motion in HP 3PAR Management Console Manager