Operating System Software User Manual

3PAR InForm Management Console 4.1.0 User’s Guide
120 320-200231 Rev A
The Summary tab is divided into an upper pane and a lower pane. The upper pane displays
a summary of all system ports. The lower pane displays detailed information about a single
port selected from the upper pane.
Upper Pane
Lower Pane
Upper Pane
The upper pane provides the following information:
Column Description
Position Port location.
WWN/MAC
World Wide Name or Media Access Control address of the connected
device.
State The state of the port. See System and Component Status Icons.
Type Indicates whether the port is FC, iSCSI, RCIP, or RCFC.
Connected
Device Type
Type of device that the port is connected to. Free, Disk, Host, or
InServ.
Connected
Device
Name of device that the port is connected to, e.g. host1, cage0.
Mode
Port firmware mode setting. Ports in Initiator mode are connected to
drive cages and ports in Target mode export to hosts. Suspended
mode is for target ports that have not yet been initialized by the
system (rare). Peer mode is for Ethernet ports.
Lower Pane
The lower pane provides detail information about a selected port from the upper pane.
Information is presented on up to four tabs, which includes a Summary tab, and,
depending on your system setup, Physical Disks, SFP, Sessions, or Hosts. Each are
discussed in detail in the following:
Port_Details_Summary
Physical_Disks
SFP
Sessions
Hosts