Operating System Software User Manual

3PAR InForm Management Console 4.1.0 User’s Guide
382 320-200231 Rev A
Creating Remote Copy Links
Note: Only two Remote Copy links are allowed.
To add a Remote Copy link:
1. Access
the Remote Copy Links screen.
2. In the right pane, right-click in the table of the system on which you wish to create a
link and select Create Link.
The Create Remote Copy Link dialog box appears.
3. A graphical representation of each system's Remote Copy ports appears under Create
Links. Click and drag from one port on one system to a port on the other system.
Repeat for a second port.
4. For IP links, in the IP Settings groups for each system/port, all fields are automatically
populated based on the link relationship you established under Create Links.
a. (Optional) Enter the gateway address for each system/port.
b. (Optional) Click Apply
to test the link configuration, or Ping to test the
communication between the links.
5. For Fibre Channel links, in the Settings groups for each system/port:
a. Connection Type - Select Point for point-to-point mode or Loop for arbitrated loop
mode.
b. Configured Rate - Select 1, 2, 4 Gbps, or Auto (default).
c. Click Apply to test the link configuration.
6. Click OK.
See also:
Viewing Remote Copy Links
Removing Remote Copy Links
To remove a Remote Copy link:
1. Access
the Remote Copy Links screen.
2. In the right pane, select the link(s) you wish to remove.
3. Right-click the selection and then click Remove Link.
The Remove Remote Copy Link(s) dialog box appears.
4. (Optional) If you wish to remove the selected link and its peers at the same time, select
Remove peer Remote Copy links.
5. Click OK.