Troubleshooting

Table 11 checkFailover Troubleshooting Checklist (continued)
Troubleshooting TipsExample of Key Log MessageProblem DescriptionProblem Area
This error indicates that
the requested group for
[2010-05-27 16:33:37.734 'TPDSrm.
testFailoverStart.Run' 3PAR_1022 error
Invalid Remote Copy
group.
Check Remote
Copy group
status. checking is not available(id=1580)] Error. The specified group
in the storage array.<MmmtGroup1.r26> does not exist in the
storage array. Contact your storage
administrator and validate
the finding.
This error indicates that
the volumes participated
[2010-05-27 16:48:24.953 'TPDSrm.
testFailoverStart.Run' 3PAR_1021 error
Invalid volume state.
in the Remote Copy(id=860)] Error. The secondary volumes are
not in Synced state. groups are not in sync. If
the Remote Copy group is
started and the Remote
Copy link is healthy, HP
3PAR SRA requires all
volumes to be in synced
state for test failover
operation.
This warning indicates
that the Remote Copy link
[2010-05-27 17:44:41.375
'TPDSrm.checkFailover.Run' 3PAR_2003
Remote Copy group is
not started.
is up, but the Remotewarning (id=5636)] Warning. Remote Copy
Group <srmgrp.r256> might not be in sync. Copy group is not started.
If the user chooses to
perform failover despite
the warning message, the
data in the target site will
not be consistent with the
data on the source site.
36 Workflows and Corresponding Log Messages