User Guide

5. Put the tray into the product.
Load optional Tray 3
Tray 3 is an optional accessory tray that attaches to the bottom of the product. It can hold longer media, such
as legal (216 x 356 mm, 8.5 x 14 inches) paper.
NOTE: If you are not using Alternate Letterhead Mode (ALM), place the paper with the side to be printed on
face-up, with the top edge toward the left side of the tray. For ALM orientation, see Load letterhead or
preprinted forms.
1. Pull the tray out of the product.
2. Open the paper length and width guides completely.
3. Place the paper in the tray and make sure that it is at at all four corners. Close the length and width
paper guides against the loaded media.
48 Chapter 4 Paper and print media ENWW