User Guide

Page 3-29
Physical constants in the calculator
Following along the treatment of units, we discuss the use of physical
constants that are available in the calculator’s memory. These physical
constants are contained in a constants library activated with the command
CONLIB. To launch this command you could simply type it in the stack:
~~conlib~`
or, you can select the command CONLIB from the command catalog, as
follows: First, launch the catalog by using: ‚N~c. Next, use the up
and down arrow keys —˜ to select CONLIB. Finally, press the F(@@OK@@)
soft menu key. Press `, if needed.
The constants library screen will look like the following (use the down arrow
key to navigate through the library):