Maintenance and Service Guide

Front IO/User Interface (FIOUI) module
Follow these steps to remove the FIOUI module:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 12).
2. Remove the access panel (see Access panel on page 13).
3. Remove the front bezel (see Front bezel on page 14).
4. Disconnect the FIOUI module cables (1) from the system board.
5. Remove the Torx15 screw (2) that secures the module to the chassis.
6. Remove the FIOUI module (3) from the chassis.
Reverse this procedure to install the FIOUI module.
16 Chapter 4 Removal and replacement procedures