Quick Specs

QuickSpecs
HP Z2 Mini Workstation
System Technical Specifications
c05262508 — DA – 15679 Worldwide — Version 10 — August 9, 2018
Page 26
NIC LEDs (integrated)
(Green & Amber)
Yes
CPUs and Heatsinks
A T-15 Torx or flat blade screwdriver is needed to remove the CPU heatsink before the CPU can be
removed. CPU removal is tool-less
Power Supply Diagnostic
LED
Yes; this is located on the Rear of the chassis and combined with the HDD LED.
When the PSU adapter is plugged in, and the unit is powered off, the Power OK LED will glow.
Front Power LED
Yes, white (normal), red (fault)
Internal Speaker
Yes, on the side of the chassis
System/Emergency ROM
Flash Recovery
Recovers corrupted system BIOS.
Cooling Solution
Air cooled forced convection
CPU Heatsink Fan
Z2 Mini Entry & Performance CPU blower solution: 11.1 mm x 65mm x 82.1mm
Z2 Mini Performance GPU blower solution: 29mm x 103.6mm x 102.2mm
Chassis Fan
Z2 Mini G3 Entry: Single system blower
Z2 Mini G3 Performance: Dual system blower
Memory Heatsink Fan
No
HP PC Hardware
Diagnostics UEFI
HP PC Hardware Diagnostics (UEFI) enables hardware level testing outside the operating system on
many components. The diagnostics can be invoked by pressing F2 at POST, and is available as a
download from HP Support.
Access Panel Key Lock
The Kensington lock slot on the chassis serves this purpose
ACPI-Ready Hardware
Advanced Configuration and Power Management Interface (ACPI).
• Allows the system to wake from a low power mode.
• Controls system power consumption, making it possible to place individual cards and peripherals in a
low-power or powered-off state without affecting other elements of the system
Trusted Platform Module
Chip
Yes
M.2 Card Retention
Yes, all M.2 modules are retained by a single screw
Flash ROM
Yes
Diagnostic Power Switch
LED on board
Yes
Clear Password Jumper
Yes
Clear CMOS Jumper
Yes