Maintenance and Service Guide

Smart card board
Table 6-3 Smart card board description and part number
Description Spare part number
Smart card board L14374-001
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Remove the base enclosure (see Base enclosure on page 34).
3. Remove the battery (see Battery on page 45).
4. Remove the hard drive (see Hard drive (HDD) on page 37).
5. Remove the solid-state drive (see Solid-state drive (SSD) on page 39).
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) in
inserted in the reader.
Remove the smart card reader:
1. Disconnect the smart card reader cable (1) from the connector on the system board.
2. Remove the two Phillips screws (2) that secure the smart card reader to the computer.
3. Remove the smart card reader from the computer (3).
Reverse this procedure to install the smart card reader.
Component replacement procedures 47