Maintenance and Service Guide

Power connector cable
Table 6-5 Power connector cable description and part number
Description Spare part number
Power connector cable L24348-001
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Remove the base enclosure (see Base enclosure on page 34).
3. Remove the battery (see Battery on page 45).
4. Remove the hard drive (see Hard drive (HDD) on page 37).
5. Remove the solid-state drive (see Solid-state drive (SSD) on page 39).
6. Remove the right fan bracket (see Fans on page 48).
Remove the power connector cable:
1. Release the connector (1) at angle from under the heat sink.
2. Disconnect the power connector cable (2) from the connector on the system board.
3. Remove the power connector from the computer (3).
Reverse this procedure to install the power connector cable.
50 Chapter 6 Removal and replacement procedures for authorized service provider parts