HP EliteBook x360 1030 G2 - Maintenance and Service Guide

Speakers
Description Spare part number
Speakers (includes cables, left and right speakers, and two rubber isolators) 924935-001
Before removing the speakers, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 29).
Remove the speakers:
1. Disconnect the speaker cable (1) from the system board.
2. Release the ZIF connector (2) to which the card reader board cable is attached, and then disconnect
the card reader board cable from the card reader board.
3. Release the retention tabs (3) that secure the speaker cable to the keyboard/top cover.
4. Release the speaker cable (4) from underneath the card reader board cable and the retention tabs.
5. Remove the two Phillips PM2.0×2.4 screws (1) that secure the speakers to the keyboard/top cover.
6. Remove the right speaker (2).
Component replacement procedures 35