HP EliteBook x360 1030 G2 - Maintenance and Service Guide

TouchPad
Description Spare part number
TouchPad (includes NFC board cable)
NOTE: The TouchPad spare part kit does not include the TouchPad bracket or TouchPad cable.
The TouchPad cable is included in the Cable Kit, spare part number 917893-001, which also includes the
NFC board cable. The TouchPad bracket is not spared as a separate component.
924936-001
Before removing the TouchPad, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 29).
Remove the TouchPad:
1. Release the ZIF connector (1) to which the TouchPad cable is attached, and then disconnect
the TouchPad cable from the card reader board.
2. Detach the TouchPad cable (2) from the TouchPad and card reader board. (The TouchPad cable is
attached to the TouchPad and card reader board with double-sided adhesive at two locations.)
3. Release the grounding tape (3) that secures the NFC board cable to the NFC board.
4. Release the ZIF connector (4) to which the NFC board cable is attached, and then disconnect the NFC
board cable from the NFC board.
5. Remove the two Phillips PM2.0×3.4 screws (5) that secure the WLAN auxiliary transceiver and the
TouchPad to the keyboard/top cover.
6. Release the WLAN auxiliary transceiver (6).
38 Chapter 5 Removal and replacement procedures