HP EliteBook x360 1030 G2 - Maintenance and Service Guide

NFC board
Description Spare part number
NFC board
NOTE: The NFC board spare part kit does not include the NFC board cable. The NFC board cable is
included in the Cable Kit, spare part number 917893-001.
917894-001
Before removing the NFC board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 29).
Remove the NFC board:
1. Release the ZIF connector (1) to which the NFC board cable is attached, and then disconnect the NFC
board cable from the card reader board.
2. Release the grounding tape (2) that secures the NFC board cable to the NFC board.
3. Release the ZIF connector (3) to which the NFC board cable is attached, and then disconnect the NFC
board cable from the NFC board.
4. Detach the NFC board (4) from the keyboard/top cover. (The NFC board is attached to the keyboard/top
cover with double-sided adhesive.)
5. Remove the NFC board.
Reverse this procedure to install the NFC board.
40 Chapter 5 Removal and replacement procedures