HP EliteBook x360 1030 G2 - Maintenance and Service Guide

Card reader board cable
NOTE: The card reader board cable is included in the Cable Kit, spare part number 917893-001.
Before removing the card reader board cable, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 27).
5. Remove the battery (see Battery on page 29).
Remove the card reader board cable:
1. Release the ZIF connector (1) to which the card reader board cable is attached, and then disconnect
the card reader board cable from the system board.
2. Release the ZIF connector (2) to which the card reader board cable is attached, and then disconnect
the card reader board cable from the card reader board.
3. Detach the card reader board cable (3) from the card reader board. (The card reader board cable is
attached to the card reader board with double-sided adhesive.)
4. Remove the card reader board cable (4).
Reverse this procedure to install the card reader board cable.
Component replacement procedures 41