HP EliteBook x360 1030 G2 - Maintenance and Service Guide

3. Remove the ve Philllips PM2.0×3.4 screws (2) and the Philllips PM2.0×2.4 screw (3) that secure
the system board to the keyboard/top cover.
4. Lift the front edge of the system board (1) until it rests at an angle.
5. Rotate the left side of the system board (2) counterclockwise until the entire left side of the system
board is clear of the keyboard/top cover.
6. Slide the system board (3) up and forward at an angle and remove the system board.
Reverse this procedure to install the system board.
Component replacement procedures 45