HP EliteBook x360 1030 G2 - Maintenance and Service Guide

Fingerprint reader board
Description Spare part number
Fingerprint reader board (includes double-sided adhesive)
NOTE: The ngerprint reader board spare part kit does not include the ngerprint reader board cable.
The ngerprint reader board cable is included in the Cable Kit, spare part number 917893-001.
917891-001
Before removing the ngerprint reader board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 27), and then remove the following components:
a. Battery (see Battery on page 29)
b. Solid-state drive (see Solid-state drive on page 30)
c. Fan (see Fan on page 34)
d. Speakers (see Speakers on page 35)
e. System board (see System board on page 43)
Remove the ngerprint reader board:
1. Detach the ngerprint reader board cable (1) from the keyboard/top cover. (The ngerprint reader
board cable is attached to the keyboard/top cover with double-sided adhesive.)
2. Remove the Phillips PM2.0×2.4 screw (2) that secures the ngerprint reader board and bracket to
the keyboard/top cover.
3. Remove the ngerprint reader board bracket (3).
Component replacement procedures 49