Maintenance and Service Guide

Connector board
Follow these steps to remove the connector board:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 30).
2. Remove the access panel (see Access panel on page 31).
3. Remove the front bezel (see Front bezel on page 34).
4. Remove the drive cage (see Drive cage on page 38).
Remove the connector board:
1. Remove the two Phillips PM2.0×3.5 screws (1) that secure the connector board to the system board.
2. Remove the connector board (2).
NOTE: When the connector board is removed, make sure the connector board bracket does not become
separated from the board.
Reverse this procedure to install the connector board.
Connector board 51