User Guide

Update the printer
By default, if the printer is connected to a network and Web Services has been enabled, the printer automatically
checks for updates.
To enable the printer to automatically check for updates
1. When HP Web Services are enabled during printer setup, the printer will automatically be enrolled to check
for updates.
2. To turn auto-updates o, turn o Web Services rst.
To update the printer using the embedded web server
1. Open the EWS.
For more information, see Open the embedded web server on page 34.
2. Click the Tools tab.
3. In the Printer Updates section, click Firmware Updates, and then follow the onscreen instructions.
NOTE: If prompted for a password, enter the PIN from the label on your printer. It might be near the cartridge
access area inside the printer or on the back, side, or bottom of the printer.
NOTE: If prompted for proxy settings and if your network uses proxy settings, follow the onscreen instructions
to set up a proxy server. If you do not have the details, contact your network administrator or the person who set
up the network.
NOTE: If a printer update is available, the printer downloads and installs the update, and then restarts.
42 Chapter 4 Printer management tools ENWW