User Guide

Setting up the monitor
Installing the monitor stand
IMPORTANT: To prevent damage to the monitor, do not touch the surface of the LCD panel. Pressure on the
panel may cause nonuniformity of color or disorientation of the liquid crystals. If this occurs, the screen will
not recover to its normal condition.
1. Position the monitor head facedown on a at surface covered by protective sheet made of foam or a
clean, dry cloth.
2. Slide the top of the mounting plate on the stand under the upper lip of the recess in the back of the
monitor head (1).
3. Lower the bottom of the stand's mounting plate into the recess until it snaps into place (2).
The latch on the bottom of the mounting plate pops up when the stand is locked in place.
Mounting the monitor
The monitor head can be attached to a wall, swing arm, or other mounting xture.
NOTE: This apparatus is intended to be supported by a UL- or CSA-Listed wall-mount bracket.
IMPORTANT: This monitor supports the VESA® industry-standard 100 mm mounting holes. To attach a
third-party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, 10 mm-long screws. Longer
screws must not be used because they may damage the monitor. It is important to verify that the
manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of
the monitor head. For best performance, it is important to use the power and video cables provided with the
monitor.
Setting up the monitor 5