User Guide

Installing a security cable
You can secure the monitor to a xed object with an optional security cable available from HP.
Mounting the monitor
The monitor head can be attached to a wall, swing arm, or other mounting xture.
NOTE: This apparatus is intended to be supported by a UL- or CSA-Listed wall-mount bracket.
IMPORTANT: This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, 10 mm-long screws. Longer screws
must not be used because they may damage the monitor. It is important to verify that the manufacturer’s
mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor
head. For best performance, it is important to use the power and video cables provided with the monitor.
Removing the monitor stand
IMPORTANT: Before beginning to disassemble the monitor, be sure that the monitor is turned o and all
cables are disconnected.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor facedown on a at surface covered by a soft clean cloth.
3. Push up on the latch near the bottom center of the stand’s mounting plate (1).
4. Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2).
Setting up the monitor 13