HP DesignJet T100 and T500 Printer series - Legal Information

94304, USA
[phone]
Eksponering for radiofrekvensstråling
FORSIGTIG: Den udstrålede udgangseekt fra denne enhed er langt under FCC-grænserne for eksponering for
radiofrekvens. Alligevel skal enheden anvendes på en sådan måde, at risikoen for kontakt med personer under
normal brug minimeres. Dette produkt og alle vedhæftede eksterne antenner, hvis dette understøttes, skal
placeres på en sådan måde, at risikoen for kontakt med personer under normal drift minimeres. For at undgå
risikoen for at overskride FCC-grænserne for eksponering for radiofrekvens må ingen mennesker opholde sig
inden for 20 cm fra antennen under normal drift.
Oplysninger om ENERGY STAR®
Se http://www.hp.com/go/energystar/ for at nde frem til dette produkts ENERGY STAR-kvalikation. ENERGY
STAR og ENERGY STAR-mærket er registrerede varemærker i USA.
Strømforbrug
HP-udstyr til udskrivning og billedbehandling, der er mærket med ENERGY STAR® -logoet, er
kvalicerede til det amerikanske Environmental Protection Agencys ENERGY STAR-
specikationer for billedbehandlingsudstyr. Det følgende mærke vises på produkter, der er
kvaliceret til at være ENERGY STAR-billedbehandlingsprodukter:
Der er yderligere oplysninger om modeller vedrørende kvalicerede ENERGY STAR-
billedbehandlingsprodukter vises på http://www.hp.com/go/energystar/.
Canada
Normes de sécurité (Canada)
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numériques de Classe B prescrites dans le réglement sur le brouillage radioélectrique édicté par le
Ministère des Communications du Canada.
DOC statement (Canada)
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out
in the Radio Interference Regulations of the Canadian Department of Communications.
Notice to users in Canada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
WARNING! Exposure to Radio Frequency Radiation. The radiated output power of this device is below the Industry
Canada radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the
potential for human contact is minimized during normal operation.
To avoid the possibility of exceeding the Industry Canada radio frequency exposure limits, human proximity to
the antennas should not be less than 20 cm (8 inches).
DAWW Lovmæssige erklæringer 9