HP DesignJet T100 and T500 Printer Series - Legal Information

94304, USA
[phone]
Exposure to radio frequency radiation
CAUTION: The radiated output power of this device is far below the FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact during normal
operation is minimized. This product and any attached external antenna, if supported, shall be placed in such a
manner to minimize the potential for human contact during normal operation. In order to avoid the possibility of
exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm
(8 in) during normal operation.
Information regarding ENERGY STAR®
To determine the ENERGY STAR qualication of this product, see http://www.hp.com/go/energystar/. ENERGY
STAR and the ENERGY STAR trademark are registered U.S. trademarks.
Power consumption
HP printing and imaging equipment marked with the ENERGY STAR® logo is qualied to the
U.S. Environmental Protection Agency’s ENERGY STAR specications for imaging equipment.
The following mark will appear on ENERGY STAR qualied imaging products:
Additional ENERGY STAR qualied imaging product model information is listed at
http://www.hp.com/go/energystar/.
Canada
Normes de sécurité (Canada)
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numériques de Classe B prescrites dans le réglement sur le brouillage radioélectrique édicté par le
Ministère des Communications du Canada.
DOC statement (Canada)
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out
in the Radio Interference Regulations of the Canadian Department of Communications.
Notice to users in Canada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
WARNING! Exposure to Radio Frequency Radiation. The radiated output power of this device is below the
Industry Canada radio frequency exposure limits. Nevertheless, the device should be used in such a manner that
the potential for human contact is minimized during normal operation.
To avoid the possibility of exceeding the Industry Canada radio frequency exposure limits, human proximity to
the antennas should not be less than 20 cm (8 inches).
ENWW Regulatory statements 9