HP DesignJet T100 and T500 Printer Series - User Guide
The following options are available:
● Enable/Disable wireless turns the wireless connection on or o.
● Wireless setup wizard provides an easy way to connect to a wireless network.
● Wi-Fi protected setup allows you to set up a connection with a wireless network using WPS (pushbutton or
pin) encryption.
● Network summary displays information about the wired or wireless network
● Print wireless network test runs diagnostic tests of wireless connectivity
● Print network conguration
● Advanced setup
● Select I/O timeout sets the time that the printer will wait for the driver to send a job to the printer
once the connection has been opened. Values range from half a minute to half an hour.
● Link speed sets the speed at which data are transmitted over the network. The default is Automatic.
● IP settings allows you to view or change the IP address, subnet mask, default gateway, and DNS
address.
● Hostname allows you to change the hostname.
● Restore network defaults
Congure rewall settings
Firewall features provide network-layer security on both IPv4 and IPv6 networks. The rewall provides simple
control of IP addresses that are allowed access.
NOTE: In addition to rewall protection at the network layer, the printer also supports open secure sockets
layer (SSL) standards at the transport layer for secure client-server applications, such as client-server
authentication or HTTPS Web browsing.
For rewall operation on the printer, you must congure a rewall policy to apply to specied IP trac. Firewall
policy pages are accessed through the Embedded Web Server and displayed by your Web browser. After a policy
is congured, it is not activated until you click Apply in the Embedded Web Server.
Creating and using rewall rules
Firewall rules allow you to control IP trac. Use rewall rules to allow or drop IP trac based on IP addresses and
services.
Enter up to ten rules, each rule specifying the host addresses, services, and the action to take for those
addresses and services.
Create a rewall rule
1. Open the Embedded Web Server.
2. Click the Settings tab, then Firewall Rules.
3. Click New, and then follow the onscreen instructions.
NOTE: After you click Apply, the connection to the Embedded Web Server might be temporarily disrupted for a
short period of time. If the IP address was unchanged, the Embedded Web Server connection will be enabled
again. However, if the IP address was changed, use the new IP address to open the Embedded Web Server.
22 Chapter 4 Personalizing the printer ENWW