HP DesignJet T100 and T500 Printer Series - User Guide

5. Put the blue paper stop on to the open end of the spindle, and push it towards the end of the roll.
6. Ensure the blue paper stop is pushed in as far as it goes. Check that there is no space between the roll and
the stops at both ends.
If you are a regular user of dierent paper types, you can change rolls more quickly if you preload rolls of
dierent paper types on dierent spindles. Extra spindles are available for purchase, see Accessories
on page 76.
Load a roll into the printer
To start this procedure, you must have a roll loaded on the spindle. See Load a roll onto the spindle on page 26.
1. From the front panel, tap , then Load roll.
This step is optional: if you just start feeding in roll paper, the printer recognizes that you want to load a
roll.
2. Insert the spindle into the printer, holding it by both ends. The blue hub should be on the left, as viewed
from the front of the printer.
3. If the edge of the roll is not straight or torn (sometimes due to tape used to hold end of the roll), pull the
paper slightly and cut a straight edge.
28 Chapter 5 Paper handling ENWW