HP DesignJet T100 and T500 Printer Series - User Guide

After unloading, the multi-sheet tray is the default active paper source.
Load a single sheet
NOTE: Roll paper and single sheets use the same input slot in the printer.
NOTE: Sheets of width 329 mm (12.95 in) or less should be loaded from the multi-sheet tray.
1.
At the front panel, tap , then Load single sheet.
2. If a roll is already loaded, you have to wait while it is automatically unloaded.
3. Select your paper category and type. If you do not see your paper type in the front panel, tap More paper
types. If you still cannot nd your paper type in the whole list, see Paper type is not in the driver
on page 84.
4. When prompted by the front panel, insert the sheet into the right-hand side of the input slot.
WARNING! Do not push your ngers inside the printer's paper path.
5. Align the sheet with the blue line.
6. Tap OK on the front panel to feed the paper into the printer. Guide the sheet into the printer; this is
especially important with thicker papers.
7. The printer checks the alignment and measures the sheet.
NOTE: Depending on the width of the sheet, it feeds out the front of the printer.
8. If the sheet is not correctly aligned, you may be asked to reload it.
NOTE: If you have an unexpected problem at any stage of the paper loading process, see Paper cannot be
loaded successfully on page 82.
30 Chapter 5 Paper handling ENWW