User's Manual

Power Switch/LED Assembly
1. Prepare the computer for disassembly (Preparation for Disassembly on page 22).
2. Remove the access panel (Access Panel on page 23).
3. Lay the computer on its side with the front facing toward you.
4. Remove the front bezel (Front Bezel on page 24).
5. Disconnect the cable from the black system board connector.
6. Press the tabs (1) (2) on the back side of the power switch to disengage it from the chassis,
slide the switch outwards to disengage the tabs from the chassis, and then pull the power switch
away from the chassis while guiding the wires through the hole in the chassis
Figure 5-8 Removing the power switch/LED assembly
To install the power switch/LED assembly, reverse the removal procedures.
.
34
1
2