Installation manual

2-10 Installing the Print Server
For persistent problems, refer to the troubleshooting sections in the
HP JetDirect administrator’s guide supplied electronically on the
HP JetDirect CD-ROM.
Step 6. Configure the Card for
Network Operation
If the card has been successfully installed and is operating correctly,
you are now ready to configure the card for network operation. You
can configure the card using the following methods:
●
Use the installation and configuration software on the
HP JetDirect CD-ROM. On Microsoft Windows 95/98/NT/2000
systems (Microsoft or Novell NetWare networks), the CD-ROM
installation utility will guide you through the entire printer setup
process.
●
Use HP printer management software (such as HP Web
JetAdmin) or other network utilities. HP printer management
software can be downloaded from HP’s Customer Care Center
(www.hp.com/support/net_printing). For additional information,
see the HP JetDirect administrator’s guide supplied
electronically on the CD-ROM.
●
Use the printer’s control panel (for printers with a supported
control panel) to configure basic network parameters on the card.
See chapter
3
in this guide.
●
Once the HP JetDirect card has been configured for TCP/IP
operation, use a supported network browser to access the
embedded web server on the HP JetDirect card. See chapter
4
in
this guide.
●
Once the HP JetDirect card has been configured for TCP/IP
operation, use the Telnet services provided on the HP JetDirect
card. See the HP JetDirect administrator’s guide supplied
electronically on the CD-ROM.
S00eiohw.book Page 10 Thursday, February 24, 2000 2:26 PM