Installation manual

3-4 Control Panel Configuration
Configuring IPX Frame Types
On IPX/SPX protocol networks (for example, Novell NetWare), the
format of network communication frames must be specified on the
card. In most cases, you can keep the default Frame Type setting,
which is AUTO (“Automatic”). However, you can manually set the
frame type format if required.
Note that the IPX/SPX protocol must be enabled (IPX/SPX=ON*)
before you can configure frame types.
IPX Frame Types on an HP JetDirect Ethernet
Card
IPX Frame Types on an HP JetDirect Token Ring
Card
Frame Type Description
AUTO (default) Automatically senses and limits the frame type to the first
one detected.
EN_8023 Limits the frame type to IPX over IEEE 802.3 frames. All
others will be counted and discarded.
EN_II Limits the frame type to IPX over Ethernet Frames. All
others will be counted and discarded.
EN_8022 Limits the frame type to IPX over IEEE 802.2 with IEEE
802.3 frames. All others will be counted and discarded.
EN_ SNAP Limits the frame type to IPX over SNAP with IEEE 802.3
frames. All others will be counted and discarded.
Frame Type Description
AUTO (default) Automatically senses and limits the frame type to the first
one detected.
TR_8022 Limits the frame type to IPX over IEEE 802.2 LLC with
IEEE 802.5 frames. All others will be counted and
discarded.
TR_ SNAP Limits the frame type to IPX over SNAP with IEEE 802.5
frames. All others will be counted and discarded.
S00eiohw.book Page 4 Thursday, February 24, 2000 2:26 PM