Installation manual

3-8 Control Panel Configuration
Configuring TCP/IP Parameters
Using the control panel of your printer, you can manually configure
these TCP/IP parameters:
Parameter Description
BOOTP YES (default) enables TCP/IP configuration
automatically from the network using BOOTP/TFTP,
DHCP, or RARP.
If BOOTP=YES*, none of the remaining parameters can
be configured from the control panel.
NO disables BOOTP, and allows you to configure the
remaining parameters from the printer’s control panel.
IP Address The JetDirect card’s unique TCP/IP network address,
consisting of 4 bytes:
IP BYTE1.IP BYTE2.IP BYTE3.IP BYTE4
(example: 015.024.227.113).
Subnet Mask A bit mask filter used to identify the subnet of the JetDirect
card if subnetting is used, consisting of 4 bytes:
SM BYTE1.SM BYTE2.SM BYTE3.SM BYTE4
(example: 255.255.248.0)
Syslog Server IP
Address
The IP address of the log server to be used by the
JetDirect card consisting of 4 bytes:
LG BYTE1.LG BYTE2. LG BYTE3.LG BYTE4
Default Gateway The IP address of the gateway used to communicate with
stations outside the local subnet consisting of 4 bytes:
GW BYTE1.GW BYTE2.GW BYTE3.GW BYTE4
Timeout The TCP/IP idle time-out period (in seconds). The value
can range from 0 to 3600. The default is 90.
If set to “0”, the timeout feature of the HP JetDirect card
is disabled—TCP/IP connections will remain open until
closed by the server.
S00eiohw.book Page 8 Thursday, February 24, 2000 2:26 PM