Hardware Reference Guide
8. Connect the power cable (1) and data cable (2) to the rear of the hard drive.
NOTE: If the 2.5-inch hard drive is the primary drive, connect the other end of the data cable to the
dark-blue SATA connector on the system board labeled SATA0. If it is a secondary hard drive, connect the
other end of the data cable to one of the light-blue SATA connectors on the system board.
9. Rotate the drive cage back down to its normal position.
IMPORTANT: Be careful not to pinch any cables or wires when rotating the drive cage down.
10. Replace the front bezel.
36 Chapter 2 Hardware upgrades










