Maintenance and Service Guide

6. Connect the power cable and data cable to the rear of the drive.
7. Connect the opposite end of the data cable to one of the light-blue SATA connectors on the system board
labeled SATA1 or SATA2.
NOTE: Refer to System board connections on page 23 for an illustration of the system board drive
connectors.
8. Reassemble the computer.
Removing a 3.5-inch hard drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Disconnect the power cable (1) and data cable (2) from the rear of the hard drive.
34 Chapter 4 Removal and replacement procedures