Maintenance and Service Guide

Hood sensor
The hood sensor is attached to the rear of the chassis.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Remove the drive cage (Drive cage on page 22).
4. Disconnect the hood sensor cable from the system board connector labeled HSENSE (1).
5. Slide the hood sensor out of the slot on the rear of the chassis (2). A tool such as a screwdriver may be
required to disengage the hood sensor from the slot.
To install the hood sensor, reverse the removal procedure.
Hood sensor 47